The EnergyMiser™ Hybrid Heating system features a 96% AFUE Two-Stage, Variable-Speed Gas Furnace packaged along with our most efficient 18 Seer EnergyMiser™ Heat Pump. The EnergyMiser™ Hybrid system takes advantage of both heating technologies and automatically switches to the one most efficient for the temperature. When it is chilly, the system operates off electricity, providing the heat pump’s steady, mellow heat. But when it turns cold, the hybrid system automatically switches to the gas furnace and its warmer, toasty air. The result is the ultimate in comfort. Even better, hybrid systems cost less to operate, because they use the most efficient technology needed to keep your home warm.

The EnergyMiser 96% AFUE Two-Stage, Variable-Speed Gas Furnace features our patented, heavy-duty, Heat-Miser™ stainless-steel heat exchanger and recuperative coil. The next-generation SecureStart™ silicon nitride hot surface The EnergyMiser Heat Exchanger ignition system increases reliability. These furnaces are completely assembled at our factory and run-tested for heating or combination heating/cooling applications. With a heavy-gauge, reinforced, wrap-around insulated steel cabinet and durable baked enamel finish, these units can be installed in a utility room, closet, alcove, basement or attic.

• Patented, heavy-duty, Heat-Miser™ stainless-steel heat exchanger and recuperative coil for maximum efficiency
• Energy-saving, reliable next-generation SecureStart™ silicon nitride hot surface ignition system
• Auto-Comfort mode helps to efficiently create and maintain a comfortable climate by intuitively adjusting to the room’s environment
• 2-stage gas valve and super-efficient, quiet variable-speed blower motor
• Quiet, 2-speed induced draft blower assembly
• Integrated furnace control with improved diagnostics
• Low voltage terminal blocks
  Multiple flame roll-out switches, blower door safety switch, outlet air- limit switch and pressure switch for proof of combustion air
• 40VA transformer for heating and air conditioning control service
• Combination redundant 2-stage gas valve and regulator
• Top venting is standard; alternate flue/vent located on right side
• Completely assembled, factory run-tested furnace for heating or combination heating/cooling application
• Suitable for direct vent (2-pipe) or non-direct vent (1-pipe) applications
• Heavy-gauge, reinforced, fully insulated steel cabinet with durable baked-enamel finish
• Attractive architectural gray paint finish
• Foil-face insulation-lined heat exchanger compartment